1-Ton Axle Swap For Project Rock Spider (YJ)

1-Ton Axle Swap For Project Rock Spider (YJ) - TECH ARTICLE

Introduction Page

1-TON Axles for Project Rock Spider
Installation & fab work done in house

Project Introduction
This jeep has come a long ways over the years. And with all the modifications this Jeep has seen the 1-tons have been long awaited for far more than any other. The "almost" unbreakable drivetrain is something dreamt about by most rock crawlers at one point or another. Or maybe I'm the only one dreaming about stuff like this? But I don't think so. Stronger components opens up a whole new avenue of crawling. A confidence in knowing you can push your rig harder and further than ever before. These new axles should hold up to anything project Rock Spider can dish out. Especially behind our 4.6L stroker motor and auto transmission. To top it all off we used some great products from our sponsors which added extra strength and quality to these axles making them that much better. Check out the articles below!

Project Sponsors

Click on Image to View Articles

Page 1
Junkyard 14 Bolt Rear
5.38's, Detroit Locker, Trussed, & More

Axle Spec's

- Gear Ratio: 5.38
- Locker: Detroit
- Axles: 30 spline 1.5" OEM
- Bolt Pattern: 8 on 6.5"
- WMS Width: 63.5"

Other: Trussed, 3/8" thick diff cover, 1/2" thick pinion guard, DRW Hubs & Disc Brakes

Click Here
to view rear axle build

Page 2
Currie RockJock 60 Front
5.38's, Spool, F450 Knuckles & More

Axle Spec's

- Gear Ratio: 5.38
- Locker: Spool
- Axles: 35 spline Inner & Outer w/CTM's
- Bolt Pattern: 8 on 6.5"
- WMS Width: 64.5"

Other: F450 Knuckles, Wilwood Calipers & Warn Premium Hubs

Click Here
to view front axle build

Photo Gallery

Keywords

introduction page axles project rock spider rear axle front jeep long more than other one i up new these out sponsors articles click view 1 bolt 5 38 s detroit locker trussed & spec gear ratio spline pattern 8 6 wms width thick 2 hubs here build spool f450 knuckles rating article edit

0 Comments | Rating: (0 rates)

Commenting option has been turned off for this article.